I purchased this terminal block to replace the melted one on my Melzi. [
cgi.ebay.ca]
Could someone verify that it will be an adequate replacement for the PSU connection on the Melzi before I solder it on. The specs are below:
Rated Current: 16A
Rated Voltage: 300V AC
Contact resistance: 20mΩ
Insulation Resistance: 5000mΩ / 1000V
Withstanding Voltage: AC1500V / 1min
Wire Range: 14-22A WG / 2.5mm
Poles: 2P
Pitch: 5.0mm
Screw Type: Philips Screw
Strip Length: 4.5-5mm
Temp Range: -30°C - +120°C
MAX Soldering: +250°C for 5 sec
Torque: 0.5Nm (3.6 lb.in)