[MONDRIAN] Y and X sliders assembly problems
Posted by xoan
|
[MONDRIAN] Y and X sliders assembly problems June 28, 2015 10:37PM |
Hi,
I'm currently planning to make an indie build of Mondrian, and I have some problems by testing the Y sliders
Thanks!
I'm currently planning to make an indie build of Mondrian, and I have some problems by testing the Y sliders
- Motor screw holes are 3.5mm depth, and RP part is 25mm, so M3x30 countersunk screw needs 5mm. I solved by using 4 M3 washers as spacer.
- Screws that holds the 603 bearings (5mm depth) cannot be screw at all because the separation between small protusions are 5.20mm and it bends and lock the extrusion.
Thanks!
|
Re: [MONDRIAN] Y and X sliders assembly problems July 10, 2015 06:08AM |
Hi Xoan !
Nice to know that you are going to build a Mondrian
1) depending on motors the screw hole is more or less deep, ours are just enough to hold the screw but 0.5mm maybe, using washer as spacers is a good idea
2) in fact the screws are used to adjust the play, like the four grubscrew for the other direction
about // liberapay // flickr // wiki // thingiverse - github
Nice to know that you are going to build a Mondrian
1) depending on motors the screw hole is more or less deep, ours are just enough to hold the screw but 0.5mm maybe, using washer as spacers is a good idea
2) in fact the screws are used to adjust the play, like the four grubscrew for the other direction
about // liberapay // flickr // wiki // thingiverse - github
Sorry, only registered users may post in this forum.