Welcome! Log In Create A New Profile

Advanced

Ramps and Hot End on D8

Posted by Roger123D 
Ramps and Hot End on D8
December 25, 2017 09:46PM
Using Ramps 1.4 with repetier firmware and for some reason the hot end heater using D10 is somehow not working on that pin but works on D8 . It works ok there but schematics all show it on D10. Should I change this or leave as there is no heatbed currently used but plan for one. ? what specific setting is wrong and can I change in EEPROM or must it be done in config.
Sorry, only registered users may post in this forum.

Click here to login