My repetier host excactly knows which layer is printed. It says so at the bottom : Layer n / nn
However, when I look into the Gcode, I can see z-axis positioning but that is not the same as layer hight.
My Gcode inserts a lot of extruder raises while travelling, so a number of absolute Z-positioning are not the same as the layer hight it is printing.
What should I do to insert custom Gcode at the place of the intended layer I want it in ?
Finding the first z-hight is not correct, I have found out .....
advice is appreciated.
Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)