Repetier Host and Marlin firmware Compatible?

Hi all,

I've just set up my new 3D printer (helloBEEprusa Serial 1111500275-to-X). The machine works fine itself, but I am finding it impossible to connect it with Repetier-Host software.

The firmware of the printer is Marlin 1.1.0-RC3.

So my question is, is Repetier Host compatible with this firmware? The program shows this error message: "Unknown printer firmware".

Is there anything I can do to make it compatible?

I am using a MAC !

I need Repetier Host since it has manual control.

Thank you very much, any help will be appreciated!

Alright, I just found the solution, if anyone is interested or has the same problem.

It was the baud rate. I just needed to the correct one (in this case, 250000).

Thank you anyway and I hope someone will find this interesting!