Hey guys, just installed a new SSD and win 7. After reloading Repetier 1.6.0 I am getting no control. Drivers installed, click "Connect" and everything appears to connect but no movement or heating. Changed baud rate to 115200 as in last install but no change. Oddly enough I just tried connecting without printer turned on and connection acted the same. It appears to have connected but it can't be. The usual pop up that appears when printer is off didn't pop up.I have an older Z605 and have never been able to communicate with the printer . No mcode commands return any info. Any ideas besides a new main board upgrade?
