Trying to set up auto bed leveling with a servo, but i'm getting a compile error.
"HAL.cpp:602:2: error: #error No servo support for your board, please diable FEATURE_SERVO".
Is there a workaround or do i need a new board to get the servo going? I saw an old post about this, but i didn't understand the solution or if it would work for me.
What i think i understood is that there was a software solution for that problem.
Link:
Old post
Repetier-Firmware version 0.92.9
Photo of board attached.
Attachments:
open |
download -
13054394_10154463571585681_1592214850_o.jpg
(242.8 KB)