Hi,
I am switching from Marlin to Repetier and it works fine ... so far
Only Problem I have is that I can not define "where" my Z-Probe should do its Z homing run. On marlin I used to do the Z home in the middle of the print bed.
Do I have to use the "Probe start script" to move the probe to the bed center? Otherwise my probe is outside the bed if I home x and y first.
Thx for any help
Cheers
Axel
Prusa i3 Advanced Laser Cut / Marlin 1.1.0-RC8 / BLTouch / Pertinax Print Bed /
E3D V6 3mm - 0.4mm Nozzle / Titan Extruder with NEMA 17 Pancake Stepper