Z_Probe "Safe Position"

Hi,

I am switching from Marlin to Repetier and it works fine ... so far

Only Problem I have is that I can not define "where" my Z-Probe should do its Z homing run. On marlin I used to do the Z home in the middle of the print bed.
Do I have to use the "Probe start script" to move the probe to the bed center? Otherwise my probe is outside the bed if I home x and y first.

Thx for any help

---

Cheers
Axel

Prusa i3 Advanced Laser Cut / Marlin 1.1.0-RC8 / BLTouch / Pertinax Print Bed /
E3D V6 3mm - 0.4mm Nozzle / Titan Extruder with NEMA 17 Pancake Stepper

Use "Z Up, X, Y preheat Z" setting for homing order under the endstops section. The first Z home will be done at the current position, then it homes X, then Y, then heats the hotend to the selected temp then homes Z where you set it, then it moves to X0 Y0 Z0.

awesome thats what I was looking for ... could have found it myself *grrr*

---

Cheers
Axel

Prusa i3 Advanced Laser Cut / Marlin 1.1.0-RC8 / BLTouch / Pertinax Print Bed /
E3D V6 3mm - 0.4mm Nozzle / Titan Extruder with NEMA 17 Pancake Stepper