Does anybody know how to change the LCD knob direction in Repetier firmware v0.91? I have seen many threads on changing the LCD knob direction and several requesting instructions for Repetier firmware but have not seen any solution to this particular question. I have been poking around configuratio.h, pins.h, etc... looking for the LCD shield knob (encoder) step settings, but it is not obvious enough for me to figure out.
My natural tendency is clockwise(CW) for + and counterclockwise(CCW) for - for dimensions, and CW for down, CCW for up in lists. So easy enough- I would need to reverse the knob direction in all its modes.
I have an ATmega1280, RAMPS1.4, Mendel, and a Sainsmart Full Graphics LCD controller w/ SD (works as a RepRapDiscount Full Graphic smart controller in Repetier).