Hello,
I started playing around with my printer today.
I'm using this firmware: [
github.com] .
While moving around with the manual control of Repetier-Host, following error occured:
"ERROR: No move in delta segment with > 1 segment. This should never happen and may cause a problem!"
(It's in motion.cpp, Line 1204.)
Should I worry about this?
Another strange thing is, that I was able move the print head, out of the defined print shape. So the head could crash with the towers.
Is this normal?
Thank you!
Kind regards,
MK
Edited 1 time(s). Last edit at 02/21/2013 04:43PM by ähM_Key.