Hi!, I am trying to connect the LCDMightyboard Interface (REV
(Display + buttons + SD) to a RUMBA.
I want to know if it is possible to control the protocol used by "Replicator Interface LCD controll electronic board" with firmware Repetier (Using "Manual definition of display (uiconfig.h)").
The LCD is controlled by only 3 pins using the integrated circuit HEF4094B (8-stage shift-and-store register ):
STROBE
DATA
CLOCK
I means something like
this (See introduction)
Here the Replicator Interface schematic
Is it possible to configure? How I can do?
Regards!
Maxi
Edited 1 time(s). Last edit at 07/27/2015 03:55PM by tiwanacote.