Speed adjustment mid print

I would like to be able to adjust the speed mid print as a percentage of overall speed.
I think that this can be done with Marlin firmware useing M220 command but I was not sure about Repetier.
It would be great to have a "set" button with an input field.

The problem is if I am printing something large and then there are small sections they start to get all gooey because it is going to fast.
I am going to hook up a fan and try to solve my problems with it.
When I am mid print and I notice that there is a problem with speed it sure would be nice to "save it" by slowing it down a bit.

By the way thanks for putting together a great combination of software and firmware.
It makes trouble shooting and getting your printer off the ground so much better.
I am still learning the 3d ropes.

thanks,

Elephantman

I posted this in the wrong place.
I meant for it to be under the wish list section.
Sorry about that.

thanks,

Elephantman

I have planned this for the hosts. This way it will work with all firmwares.

---

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Thanks for the info.
I will be looking for it in a future release.


Elephantman

This would be awesome. I sure miss being able to do that.

Richard