ENDSTOPS_INVERTING

Its me again!

I've just changed my z endstop to an optical, leaving the x and y as mechanical. The optical is inverted compared to the mechanical, and the only setting is to invert all endstops. would it be an idea to be able to individually control each endstop, rather than all 3?
Its not a real problem as I've just wired the mechanical switches N/O, but normally a mechanical switch is wired N/C incase the wire breaks.

regards

Paul

For the next release I have added idividual endstop invert settings. Till then look into Repetier.pde around line 1450. There you can change != with == in the endstopcheck to change it's behaviour against the other settings.

---

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!