Welcome! Log In Create A New Profile

Advanced

Any Mach3 users on here?

Posted by Dirty Steve 
Any Mach3 users on here?
December 20, 2012 09:56PM
Looking for some Constant Velocity tips from Mach3 users.
Re: Any Mach3 users on here?
December 22, 2012 07:44AM
I use Mach3 when 3D printing. Whats your Question?
Re: Any Mach3 users on here?
December 23, 2012 09:35AM
have you run into a stair stepping pattern in arcs and circles? I can make it worse with CV settings but have not been able to eliminate it completely.

You can see it in this pic, mostly on the stomach of the blue pink panther woman in the background. Vertical pattern.

Got some tips from the Mach3 support forum, but still getting the pattern in my prints.

Edited 1 time(s). Last edit at 12/23/2012 10:51AM by Dirty Steve.
Attachments:
open | download - pink.jpg (72.6 KB)
Re: Any Mach3 users on here?
January 11, 2013 10:01AM
Was able to clean up the step signal a bit with a better timer capacitor on my TB6560 board.
Re: Any Mach3 users on here?
March 14, 2013 04:56PM
I'm a Mach3 CNC user but just getting into 3D printing

I built an extruder and bolted it to my CNC machine as a test
My DIY extruder experiment was a success and so I am building a dedicated printer now

slic3r created the Mach3 G code

This was my very first print and it came out great
No problems running the code in Mach3
I say great, because I had no heated bed, I did not attempt to level the bed and I had no fancy temp control unit, onlyt a variac to control the 12 volt heater on the hot end
I have some spider webs but all that can be worked out in detail once I have my new machine up and running
You can see YouTube vids of my extruder test here
[www.youtube.com]

I have a post here on my new printer build that runs on slic3r and Mach3
[forums.reprap.org]


My projects are listed here - [www.el34world.com]
Sorry, only registered users may post in this forum.

Click here to login