So I enabled "Combine infill every  layers" for infill.
to my understanding, every other layer can be skipped.
In reality: (honeycomb infill in an round object)
Stright infill lines are like that, thicker, and every other layer is skipped.
Curved infill lines (outer lines of the infill) are printed every third layer (two skip, then print) , resulting in much too little filament, and they are simply no good.
verion = 1.3.0Dev.26feb.
with cubic infill, every layer is printed..
nor can I disable it (print every infill layer), which messes up my prints.
Edited 2 time(s). Last edit at 03/16/2018 11:54PM by Andke.