Welcome! Log In Create A New Profile

Advanced

Infill not reaching the wall

Posted by Samuel.hk 
Infill not reaching the wall
September 08, 2017 02:59AM
As seen in the picture a lot of holes appear near the inner wall, they are caused by not enough sticking force when infill is much less than 100%. Plastic is pulled away from the wall during fast reverse movement of the print head. Infill overlap already set to 15%, is there any other setting that can solve this problem?
Attachments:
open | download - IMG_20170908_173322.jpg (510.6 KB)
Re: Infill not reaching the wall
September 08, 2017 04:13AM
Lower jerk value might help. Or slower infill speed in general?
Re: Infill not reaching the wall
September 09, 2017 01:56AM
Also in slic3r there is a 'infil/perimeter overlap' setting in print settings/advanced tab. you try different values to compensate backlash etc.
Sorry, only registered users may post in this forum.

Click here to login