I am not sure whether this is a Slic3r or the printer itself but does anyone have any idea why the toolhead movement on the top layer is so erratic thus causing all the noticeable blobs and imperfections?
Attaching pictures and videos for reference, print parameters included
I don´t see erratic movements. I think you print too fast for those little segments, imperfections build up in the turning points causing high pressure in the thicker points and blobs in the thinners. Make more perimeteres to avoid little segments.or concentric top/bottom. Better is top solid infill 25 mm/s.
Edited 3 time(s). Last edit at 08/31/2017 05:55AM by sliceheart.