Welcome! Log In Create A New Profile

Infill/Vertical shell overlap?

Posted by khondoke

khondoke

Infill/Vertical shell overlap?
August 23, 2017 04:09PM

Registered: 8 years ago
Posts: 6

Hello, I see there is an option in Slic3r to control overlap between infill and perimeter. How about overlap between interior vertical shell and infill? Can we control that also in Slic3r? I have attached a photo for better understanding of what I meant.

overlap.jpg

. Thanks in advance.

Reply Quote

dmould

Re: Infill/Vertical shell overlap?
August 25, 2017 02:12PM

Registered: 10 years ago
Posts: 2,472

As far as I am aware, "perimeter" is used to describe any vertical shell whether it be interior or exterior, so I would expect the overlap to apply to both (but have not tried it)

Consider he case where the interior tube in your example is sloping so that it intersects the outer perimeter at some height. At that point is would become the outside perimeter.

Dave