Welcome! Log In Create A New Profile

Advanced

Z going mad with two extruders and raft

Posted by sliceheart 
Z going mad with two extruders and raft
March 23, 2017 09:02AM
When I make raft with two extruders the support extruder goes 0.6 mm in Z instead of 0.4 mm and later this behaviour continues. I have read Gcode and is correct, slicer doesn´t use layer thicness. With this Z the raft is ruined, ¿can I make something?
Re: Z going mad with two extruders and raft
March 23, 2017 05:59PM
If the gcode correctly commands Z = 0.4mm for both extruders, it's not a Slic3r issue and the most likely place to look is in either your firmware or EEPROM for a Z offset for one of the extruders. I can't be more specific without knowing what kind of electronics and firmware you have.
Re: Z going mad with two extruders and raft
March 24, 2017 12:13AM
I have explained the error the bad way. Checking the Gcode the second layer in Z is 0.6 mm when it should be 0.4 mm, so Slic3r 1.2.9 is wrong.
Re: Z going mad with two extruders and raft
March 24, 2017 01:45AM
I´ve checked the slicer behaviour with raft and the layer thickness is always 0.3 mm. This layer heght is too much for my filament-extruder but I can´t change it.

Just I can´t use raft

Help! I need somebody
Sorry, only registered users may post in this forum.

Click here to login