Gcode missing 2 layers?
Posted by IntentoinalTypo
|
Gcode missing 2 layers? October 17, 2016 09:08PM |
This is weird. I'm pringing out this and I notice that it seems to have skipped a couple layers. It looks fine when I see the model in the preview. I'm using the settings from prusa i3 installer. It works fine with everything else. The missing layers are between 23.35-23.55. The stl and gcode are here. Any ideas?
Edited 2 time(s). Last edit at 10/17/2016 09:12PM by IntentoinalTypo.
Edited 2 time(s). Last edit at 10/17/2016 09:12PM by IntentoinalTypo.
|
Re: Gcode missing 2 layers? October 18, 2016 07:41AM |
The gcode actually lack any printing instructions at the mentioned layers.
It might be a slic3r bug or your stl is not ready for printing, try to use a stl repair feature - google it, netfabb comes to my mind - of some sort and try again.
Maybe use a gcode preview before printing to avoid waisting your time and filament - Repetier Host does this.
BTW did you just post a d**k pic ?!?
Edited 1 time(s). Last edit at 10/18/2016 07:43AM by DeuxVis.
Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.
It might be a slic3r bug or your stl is not ready for printing, try to use a stl repair feature - google it, netfabb comes to my mind - of some sort and try again.
Maybe use a gcode preview before printing to avoid waisting your time and filament - Repetier Host does this.
BTW did you just post a d**k pic ?!?
Edited 1 time(s). Last edit at 10/18/2016 07:43AM by DeuxVis.
Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.
|
Re: Gcode missing 2 layers? November 29, 2016 05:08PM |
Hy there.
Yeap, it happens.
Happened to me in 2014, I posted in the below link the details (try google translate).
It was a slic3r bug but it happened only in that occasion.
It can't be the extruder because.. it should not recover from skipping layers.
just try another slicer :-)
http://forums.reprap.org/read.php?386,446563
Yeap, it happens.
Happened to me in 2014, I posted in the below link the details (try google translate).
It was a slic3r bug but it happened only in that occasion.
It can't be the extruder because.. it should not recover from skipping layers.
just try another slicer :-)
http://forums.reprap.org/read.php?386,446563
Sorry, only registered users may post in this forum.