This might be a bug or just a case of insufficient documentation.
I have enabled autospeed in all speed fields and that works fine, limited by max print and volumetric speed. I would like the first layer to go slower for better bed adhesion so I set first layer speed to 50%, but that has no effect on the G-code. Using 100%, 50% or 10% doesn't seem to make any difference. I guess this could be expected when enabling autospeed, but to me setting the first layer speed should work as a multiplier for the calculated first layer speeds.
Of course I can acheive what I want with a post processing script but it seems like there already is field for this in the UI.
As a side note, setting an absolute speed in mm/s for the first layer works fine.
Any commennts? Is it a bug?
Best regards,
Wileur
Attachments:
open |
download -
slic3r first layer speed.png
(41.5 KB)