Calibration Infill January 06, 2016 04:11AM |
Registered: 8 years ago Posts: 4 |
Re: Calibration Infill January 06, 2016 08:45AM |
Registered: 10 years ago Posts: 2,472 |
Re: Calibration Infill January 07, 2016 10:11AM |
Registered: 8 years ago Posts: 4 |
Re: Calibration Infill January 07, 2016 03:26PM |
Registered: 10 years ago Posts: 580 |
Quote
Print the cube and analyze the top. If there is NOT ENOUGH plastic (a concave top), reduce the Infill Width over Thickness by .05 increments. If there is TOO MUCH plastic (convex top), turn that parameter up by .05 increments. In Pronterface/Skeinforge settings, this can be found either in Craft > Inset in some versions, or Craft > Fill in other versions.
Once you're feeling close, start bumping it around in smaller increments.
You may also need to adjust your feed rate.
Adjust the feed rate by increments of 2 or so until you feel close. If it looks really disgusting and blobby, go by increments of 0.5mm. Then go by smaller and smaller increments until you've nailed it. Although you probably just want to decrease Infill Width over Thickness instead of decreasing Feedrate because lowering feedrate will degrade the resolution.
Re: Calibration Infill January 08, 2016 07:18AM |
Registered: 10 years ago Posts: 2,472 |
Re: Calibration Infill January 08, 2016 01:44PM |
Registered: 10 years ago Posts: 580 |
Re: Calibration Infill January 11, 2016 09:11AM |
Registered: 10 years ago Posts: 2,472 |