Welcome! Log In Create A New Profile

I fill, I need to change setting. But I don't know which one.

Posted by yuzmemak

yuzmemak

I fill, I need to change setting. But I don't know which one.
October 03, 2015 01:10PM

Registered: 8 years ago
Posts: 13

Hi,

you can see my milenium print as follows. Everything is very good except front side of the ship. I think, if print only outside, it will be no problem. When filling inside, pla become more than neccessary.

Which setting, I need to correct?

Best Regards

Edited 2 time(s). Last edit at 10/03/2015 02:08PM by yuzmemak.

Reply Quote

Attachments:
open | download - nose_1.jpg (515.2 KB)

yuzmemak

Re: I fill, I need to change setting. But I don't know which one.
October 05, 2015 07:14AM

Registered: 8 years ago
Posts: 13

Hi,

Very strange no body answered!

I suspect to change solid infil area to 0. Could be solution?

Best Regards

Reply Quote

IMBoring25

Re: I fill, I need to change setting. But I don't know which one.
October 06, 2015 12:48AM

Registered: 9 years ago
Posts: 351

I am suspicious you're overextruding generally and the signs are just more pronounced when you have solid infill and there's nowhere for the material to go but outwards. Check your extruder calibration and make sure you don't have an extrusion multiplier much greater than 1 set in your slicer.

Reply Quote

RRuser

Re: I fill, I need to change setting. But I don't know which one.
October 06, 2015 08:53AM