Unexpected behavior with holes in model.
Posted by Koenig
|
Unexpected behavior with holes in model. July 23, 2015 10:27AM |
I'm trying to slice this: [www.thingiverse.com] I have rotated it a bit so that it lies flat on the printbed.
When it comes to the holes that runs 45 degrees though the "ears" I found that sli3r does something strange, the "inside" of the holes is way to big.
The holes are supposed to have the same dimensions throughout as the plastic is supposed to counter the threads of the screw.
What can be done?
Edited 1 time(s). Last edit at 07/23/2015 10:27AM by Koenig.
When it comes to the holes that runs 45 degrees though the "ears" I found that sli3r does something strange, the "inside" of the holes is way to big.
The holes are supposed to have the same dimensions throughout as the plastic is supposed to counter the threads of the screw.
What can be done?
Edited 1 time(s). Last edit at 07/23/2015 10:27AM by Koenig.
Sorry, only registered users may post in this forum.