Hello
I`m just testing slic3r 1.1.7 and have some troubles with the top-layer.
The infill lines are just much too large and bulky, i don`t know if i just miss a setting, or its a bug ?
the first of the toplayers is printing fine (left on the picture) but at the most top layer the infill lines are too fare away from each other, resulting also in holes when printing.
the flow is calibrated corretly, horizontal and all other lines look nice, when i raise the flow the lines become overinvill at normal perimeters/infill, so thats not the issue.
Its the same issue vice versa at the bottom layer, there is the first layer ok and the 2nd layer infill is too wide.
Chri
[chrisu02.wordpress.com]
Quadmax Intel Delid Tools