Sli3er and Delta rostock Max v2 March 03, 2015 01:45PM |
Registered: 9 years ago Posts: 2 |
Re: Sli3er and Delta rostock Max v2 March 04, 2015 08:48AM |
Registered: 10 years ago Posts: 2,472 |
Re: Sli3er and Delta rostock Max v2 March 04, 2015 06:03PM |
Registered: 9 years ago Posts: 2 |
Quote
dmould
The head should be homed during the printer initialisation or setup stage (i.e. before starting the print) so that it is just touching the bed when Z=0. If Z homing is reliable and does not require manual intervention/checking, then a homing command can be put into the start G-code in Slic3r. Slic3r will command the head to move to the first layer height at the start of the print, which will thus be higher than the zero position (as set by the homing process).
Dave
Re: Sli3er and Delta rostock Max v2 March 05, 2015 08:04AM |
Registered: 10 years ago Posts: 14,672 |
Quote
jram
I was able to export g code but for some reason my machine is showing a target temp of 0 for the hotend, even though I set it at 202 in sli3er. Any suggestions on this? The bed temp is correct but no hotend temp
Re: Sli3er and Delta rostock Max v2 March 05, 2015 09:24AM |
Registered: 10 years ago Posts: 2,472 |