Hi all. I'm new here so please forgive me for repeating a question that I'm sure has been asked before...I did a search but got nowhere.
I'm new to printing having had my machine for 3 months. I'm having some support issues which I think are down to the settings...I'm running the default settings. My supports are very flimsy and often break and fall over.
The settings as they are now are;
Pattern: Pillars
Pattern Spacing; 2.5mm
Pattern Angle; 0
Interface Layers; 3
Interface Pattern Spacing; 0
Another issue I have is that where the supports touch the sides of the model they are very hard to remove.
Any input as to where to make setting adjustments will be much appreciated.