option "vase spiral" generates a straight line in the center of the vase
Posted by GuilhermeGasperin
|
option "vase spiral" generates a straight line in the center of the vase February 08, 2015 04:11PM |
When enabled the "spiral vase", the Slic3r slice a straight line in the center of the vase
I was using the 1.1.7 version and it was, updated to version 1.2.6 and continues to occur
Obs .: when I slicing without check the "Spiral vase" these lines are not generated (in both options is generating a "column" filament)
I was using the 1.1.7 version and it was, updated to version 1.2.6 and continues to occur
Obs .: when I slicing without check the "Spiral vase" these lines are not generated (in both options is generating a "column" filament)
Sorry, only registered users may post in this forum.