Why Slic3r infill some layer %100?
Posted by RDEng
|
Why Slic3r infill some layer %100? November 08, 2014 08:11AM |
Hi everyone,
I have a problem about infill. i set the infill parameter %15 but slicer infill the some layer %100. it seems really weird print in the end. What am i missing?
As you can see the attached photo, same layer %100 which you can see easily dark layers on the shaft. some layer dark(%100) some layer is normal (%15 infill).
Why did slic3r do that? please somebody explain to me
Thank you each of you!
Custom 3D Printer,
Mechanical Engineer
I have a problem about infill. i set the infill parameter %15 but slicer infill the some layer %100. it seems really weird print in the end. What am i missing?
As you can see the attached photo, same layer %100 which you can see easily dark layers on the shaft. some layer dark(%100) some layer is normal (%15 infill).
Why did slic3r do that? please somebody explain to me
Thank you each of you!
Custom 3D Printer,
Mechanical Engineer
Sorry, only registered users may post in this forum.