Print time cooling calculation done "per part" or total? October 13, 2014 05:57PM |
Registered: 9 years ago Posts: 5 |
Re: Print time cooling calculation done "per part" or total? October 14, 2014 03:34AM |
Registered: 10 years ago Posts: 14,672 |
Re: Print time cooling calculation done "per part" or total? October 14, 2014 01:26PM |
Registered: 9 years ago Posts: 5 |
Re: Print time cooling calculation done "per part" or total? October 16, 2014 08:41AM |
Registered: 10 years ago Posts: 2,472 |
Quote
KickMe0869
I'm not a huge fan of the slowdown feature for small perimeters as it seems to radiate more heat into the part by dwelling there longer.
Re: Print time cooling calculation done "per part" or total? October 21, 2014 12:54PM |
Registered: 9 years ago Posts: 5 |
Re: Print time cooling calculation done "per part" or total? October 22, 2014 11:02AM |
Registered: 10 years ago Posts: 2,472 |
Quote
KickMe0869
That's a good idea to use a sacrificial column! Prior to building my enclosure I had luck with making a really tall wall around the part, but sometimes it would pop loose and mess everything up.
Re: Print time cooling calculation done "per part" or total? October 28, 2014 07:36PM |
Registered: 9 years ago Posts: 5 |
Re: Print time cooling calculation done "per part" or total? October 29, 2014 09:29AM |
Registered: 10 years ago Posts: 2,472 |
Quote
KickMe0869
Nice idea! I just happened to be modifying my end g-code last night and I noticed that slic3r has a gcode for layer change. You could put a pause or an orbit in there as well, or whatever you'd like to delay the print