Hello everybody. I am using slicer 1.1.7.
Ok. here is my Problem / suggestion. I hope that what i am trying to explain is understandable.
i am not talking about retraction blobs and so on.. just an usual edge on the fly printed. just little stop for accelereation...
Some of you noticed that outcoming edges that looks like there ist too much PLA. ?!?!
OK then let´s think about what does happen.
the Printer draws a line A>B the next line will be from B>C and then lats say C>A. so it´s a triangle.
the possible start and stop blob is adsustable with retract. BUT the outcoming edge AT point B...what does happen there?
well i think it is because B is (like everyother point) is 2 times per layer a point where slic3r want´s to ad PLA.
Start at A...........B(next line in code)B..........C(next line) C.........D(and so on)
when it is at b it ads it´s last amount of pla for that piece of line/layer. then it looks for the next line an want´s to go to point C.
it is at B and starts PLA and drive to C. there it stops and looks for next...... and so on.
B get´s Twice the PLA that it needs. this is for every point where 2 lines attatch each other.
we all know layerwidth. and there sould be an option to add a little extra points in front of each "line attatchpoint"
with setable distance ( something like half layerwidh as default) and flow ratio.
then we can adjust those edges. an there should be a something that recognises the angle and multiplies it with it.
At milling this is not needes because material that has been removed could not be removed twice. it´s gone at the first time.
3D printing is totaly different and so. PLA/ABS whatever can be added as often as slicer says.sometimes too much.
Oh man much text an hopefully understandable.
Well this is the problem on every Curve or edge or not straight line whatever. the innerpart of the line gets more and the outer less than needet.
Please let me know if this is already solved by a setting i didn´t find.
again: i am not talking about retraction an related ... :-)