Most easy support break away ?

I am not sure what parameter I should use to get the most ease break away support ?
Any advice ?

like pattern, pattern space or interface ? What settings are the best to get rid of te material ?

I had some trouble with my latest parts that have horizontal overhang and the support was pretty solid to it.


Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

I have had problems in the past and reduced the Advanced>Extrusion width> Support material percentage (80-90%??).

Edited 1 time(s). Last edit at 08/07/2014 09:36PM by Bill Clark.

Hi Bill,

thanks. That seems a good option.
Was not realy aware of that one :-)

I will start testing with that parameter.

Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Hi Thomas,

Try using this configurtion:

Overhang threshold: 0 (default)
Interface pattern spacing 0.5 or 1mm, depending on sizes involved
Support material width: 0 (default)

Slic3r will produce a smaller support material in size, with a nice gap to parts walls and easy to remove.

Regards.

Jose

Ok, thanks
i will do.

(Currently is my Orca down. Waiting for parts and for replacement printer. :-(

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)