Hi, I've been using Slic3r for sometime now, and like it.
But I have a strange problem, which I think might be Slic3r based.
Take a square block type of print.
The printer will do the perimeter then infill and reach the perimeter correctly.
Come the next layer and subsequent layers the infill doesn't seem to quite make it, and there is a thin gap.
If the box has rounded corners, then the HotEnd makes the trip to the edge where the radius is, but not along the edges.
I'm wondering if I have a settting wrong or something as it consistent, and yet doesn't happen on the first layer.
With that said I do have the first layer extrusion width set to 200%.
Please send me a PM if you have suggestions, or problems with Big Blue 360.
I won't see comments in threads, as I move around to much.
Working Link to Big Blue 360 Complete
