Exporting issues

I can't seem to figure out the problem with slicing times. The slicing is finishing but the exporting is taking quite a long time. I have been playing around with Simplify3D and it is so much faster, but the program just doesn't seem to really create quality gcodes. I can see quality differences and they don't have settings that you need to make the quality better.

Does anyone know how to increase speed to allow the slicing to finish sooner? I'm already using 5 threads.

Can you post the STL? Or are all your STL.s very slow to export?

---

_______________________________________
Waitaki 3D Printer

I am not sure if we have the same problem. Is "avoid crossing perimeters" active?
I found two reports on this:

[github.com]
[github.com]

Try to turn it off, worked for me.

---

3D Print Sam - Support and Material