OK, so there has probability been other posts asking how to correct the z wobble issue on a 3D printer. I only post this because the majority of these z wobble issues come from printers with prusa kennimatics. My printer is an oddity mainly because it is a delta printer that uses leadscrews. The wobble isn’t terrible enough to actually affect print surfaces, but it causes noticeable scarring on the print surfaces -especially flat ones. I know for a fact that the 8mm threaded rods are not perfectly straight, but what I do not know is how to deal with it. Do I tighten everything up, adding extra restraints to the bottoms of the rods, or do I do the opposite- loosening everything so they have room to wiggle? Attached (coming soon) are some pictures of my issues along with an image of my printer setup