corner printing issue

Hi all
Been trying to sort out why im getting bad corners when the item is standing upright on the heatbed,see pics.all others corner are fine its just seems it only overhang corners from a flat base
ive tried slowing print down less heat on the bed slower/speeding fan speed when cooling.
top corners and domes at the finish of the print are good as shown in picture.
im using prusa i3 clone PLA @210 heatbed@55
any ideas would be grateful
bad corner

bad corner

finish to corners

not a bad print without corners

Edited 1 time(s). Last edit at 03/19/2018 12:38PM by Thereaper.

Why do I see so many p0rn-ads, when I open your links???

About the overhangs: You have to use small layerheight and good part cooling to fix that problem.
Some slicers allow variable layerheight, so you can change it to normal height, when the overhang is done.

Quote
o_lampe
Why do I see so many p0rn-ads, when I open your links???

About the overhangs: You have to use small layerheight and good part cooling to fix that problem.
Some slicers allow variable layerheight, so you can change it to normal height, when the overhang is done.

porn links lol i dont see them when i open them must just be your bad pc lmao
thanks for the info will look into the layer heights im using repetier host with the cura built in to slice everything