Circle Printing Issue
Posted by merchant1307
|
Circle Printing Issue March 15, 2018 03:14AM |
Whats Wrong with this print?
[ibb.co]
Before completing the circle the extruded plastic gets thinner in width then when it completes the circle and is back in the start position it starts rising for another layer while rising for this layer it extrudes a dot of plastic in that area.
Edited 1 time(s). Last edit at 03/15/2018 03:19AM by merchant1307.
[ibb.co]
Before completing the circle the extruded plastic gets thinner in width then when it completes the circle and is back in the start position it starts rising for another layer while rising for this layer it extrudes a dot of plastic in that area.
Edited 1 time(s). Last edit at 03/15/2018 03:19AM by merchant1307.
Sorry, only registered users may post in this forum.