Welcome! Log In Create A New Profile

Advanced

Problem with my Prussia reprap i3 printer

Posted by Rasyoni 
Problem with my Prussia reprap i3 printer
January 29, 2018 08:18AM
My printer makes a squeezing sound on the motors and only x axis moves and the motor is extremely hot.
I used the Prussia Mendel_i3 marlin firmware early "Marlin firmware used for Prusa i3 Hephestos - modified for Prusa i3 Rework"
but it accept the job heats up, and when it about to start it stops and cools down.
Now i installed another version "for a Geeetech i3 X: [Firmware for Geeetech i3 X]"
and after i install when i tried it gives the above motor heating and some axis are not moving.
I follow the procedure from this site:
[reprap.org]

Pleas help me.

Edited 2 time(s). Last edit at 01/30/2018 06:19AM by Rasyoni.
Sorry, only registered users may post in this forum.

Click here to login