Welcome! Log In Create A New Profile

Advanced

Print not completing filling in one direction

Posted by Mechanoid 
Print not completing filling in one direction
January 27, 2018 09:35AM
Rep rap i3, repitier using either cura or slic3r prusa edition. Any other details I can find out just ask. It does this for all my prints now.
Attachments:
open | download - 20180127_121905.jpg (278.9 KB)
Re: Print not completing filling in one direction
February 02, 2018 10:53AM
because it happens in the same spot on all squares it appears to be an error in the design you need to print a regular cube and see. You should calibrate the extruder it could be under extrusion
Re: Print not completing filling in one direction
February 05, 2018 04:42AM
Are the "square" holes the right size? Im trying to decide if the infill is short or the perimeter is wrong.
Is that one perimeter?
Can't be missing steps or it would get progressively worse.
Can't be retraction as it only happens at one end of a run.
Are the X and Y motors the same type and have the same step settings. Its almost like a position error on one axis but it doesn't happen on both infill and perimeter.
Sorry, only registered users may post in this forum.

Click here to login