Welcome!
Log In
Create A New Profile
Home
>
Printing
> Topic
Advanced
Cleaning nozzles
Posted by
hokanp
Forum List
Message List
New Topic
hokanp
Cleaning nozzles
January 09, 2018 02:23PM
Registered: 6 years ago
Posts: 13
Hi
Anyony have a advice about how to Clean the nozzle for PLA ?
I remove the nozzle with the heater on, not possible on Cold heater.
The nozzle is after that full of PLA and it get hard quickly.
So, best tips for removing the PLA?
Thanks
Reply
Quote
JustSumGuy
Re: Cleaning nozzles
January 09, 2018 02:51PM
Registered: 6 years ago
Posts: 262
look up the 'atomic' pull method.
Basically you heat up the tip to near printing temp then pull the filament out quick, it clears alot from the tip all the way up.
then removing the tip cold is pretty easy as most of the plastic is out of there...
Edited 2 time(s). Last edit at 01/09/2018 02:53PM by JustSumGuy.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login