Good day fellow reprappers,
Do any of you know if there is a way to increase the flow rate of my prints during the slicing process with slic3r? I find that my flow rate is far too little and the only solution thus far is to increase the flow rate (150%) manually while printing infill, and set it back to 100% during solid or top layers. This is quite frustrating. I have also set the infill extrusion width to 150% with no luck.
I have read through the slic3r documentation/manual and as far as I can tell this is not possible. I just thought I would ask in any case, maybe someone knows of an alternative solution.
My top/bottom and perimeter layers are fine, it is just the infill (at say 15%) that does not extrude enough. I have tried various temperatures and speeds (slower speeds seems to work better).
Prusa i3 / Marlin
Thanks
Edited 1 time(s). Last edit at 12/16/2017 09:41AM by v1talogy.