Welcome! Log In Create A New Profile

PTFE tube being pushed out of e3d Lite 6

Posted by Willp3d

Willp3d

PTFE tube being pushed out of e3d Lite 6
August 07, 2017 06:30PM

Registered: 7 years ago
Posts: 2

I just got an e3d lite 6 and installed it, and it would not print. It would stop extruding after the first 10 layers. I took the hotend off the extruder and found out that filament was collecting at the bottom of the hotend pushing the tubing up. I am not sure what to do.

Reply Quote

WZ9V

Re: PTFE tube being pushed out of e3d Lite 6
August 07, 2017 09:42PM

Registered: 10 years ago
Posts: 293

Make sure it is inserted all the way and use something like this [www.thingiverse.com] to keep it from backing back out.