Sometimes pictures help, Thou in this case more information is required.
Is kind of sounds like between your slicing software and your 3D Printer the borders are different. Example you have a 220x270 bed that is defines as a 270x220 bed.
OR
Your configuration is off and the printer thinks it is at max on that axis.
Yes it would be help-full to have more information.
Is this factory firmware or did you setup firmware yourself, What firmware, What slicer software ect.
Can you manually maneuver the around the entire print area without being stopped at this location.
Edited 1 time(s). Last edit at 08/05/2017 01:49PM by Roberts_Clif.