Random Stopping issues.

Hi guys, thanks for adding me to the forum.
I need a little help, I have a d-bot core xy with mks base v1.5 and tft 28. I am getting random stopping issues where the print will suddenly stop causing blobs on the same corner of each layer (usually). Sometimes it will just stop anywhere for a few seconds. I have started to pull my hair out with this now as I cannot get to the bottom of it. Any help would be greatly appreciated. Thank you!

Printing via usb link or from SD card ?

Sd card, it happens with whatever card I use. It also happens if I print via usb.

I have just spent the evening moving the psu, tidying cables and making sure all connections are solid. Hopefully it works.

Well that hasn't made a difference lol.

Well, I think I have narrowed it down to the tft display. I have removed the display completely and I am printing over usb link and the issues seem to have gone. I have ordered a 12684 display instead.

TFT and full graphic displays need a lot of processor time so maybe your 8 bit arduino just cant keep up,
Would be better to upgrade to a 32 bit board

Tbh I'll just stick with an lcd for now. I'll upgrade to 32bit at a later date.
Thanks!

Edited 1 time(s). Last edit at 06/26/2017 03:30AM by jamie16v.