So I am sure there is someone out in the community that has seen this before, and I wanted to reach out to get some insight. I did do some searching on the forums, but I was not able to find exactly what I was looking for. I have auto bed leveling on, and I know it works (the z-axis motors move constantly to adjust for the measured bed height deltas). However, I am still seeing quite a bit of variation in the height of the bed and the thickness of the printed filament. Are there any other answer besides 'lower the height of the bed on the front right'? Why would the autoleveling function not account for this? Thanks.
Attachments:
open |
download -
Uneven_Bed_Print.jpg
(463.3 KB)