Welcome! Log In Create A New Profile

Advanced

Difference in printing

Posted by DOYT 
Difference in printing
March 15, 2017 08:03AM
Hi. I just wondering why do I have such an ugly printing on the belly, on the bottom of this frog and why is so nice and smooth on the top? I m using an original e3dv6 full with qualitative pla filament. Print quality 0.1mm 60mm/sec print speed, printing temp 210/55, print fan cooling at 255. The quality on the bottom should be like it is on the top without supports. As slicer, I'm using cura 2.3.0. Opinions? Thanks!
Attachments:
open | download - rsz_2017-03-15_164224.jpg (224 KB)
open | download - rsz_2017-03-15_164257.jpg (187.6 KB)
open | download - rsz_2017-03-15_164407.jpg (97.3 KB)
Re: Difference in printing
March 15, 2017 08:05PM
Lower the temperature to max 195 and try again, also on small objects is best to print slow 40mm/sec max.
It might also help to increase the retraction distance, use random starting point and adjust overlap percentage.

Edited 1 time(s). Last edit at 03/15/2017 08:09PM by ggherbaz.
Re: Difference in printing
March 16, 2017 12:46AM
I have printed this part with 6.5 mm retraction distance, 45mm/s retraction speed 0% infill and printing speed 60mm/sec. I'll do the change and I'll post the differences. Thanks.
Re: Difference in printing
March 16, 2017 03:41AM
The belly is a nasty overhang - very difficult to print.
Re: Difference in printing
March 16, 2017 10:48AM
even with a prusa i3 mk2 original?
Re: Difference in printing
March 31, 2017 02:06PM
anything gets nasty, try printing lower microns and lower temps. you can also sand the bottom if you have the patience.
Sorry, only registered users may post in this forum.

Click here to login