hi all, having a problem with these medical clitorus stl prints of the net from france.
basically, cannot sort the seem join, i've pondered it a while, then tinkered, the seem join 'plus' and 'minus' on the software both make it worse, so, i'm thinking the E0 steps per mm (theyre spot on), or secondly the prime speed and or prime amount need turning up? will that sort it? any sugestions?
Thats a mighty large clitoris you have there...you know all humans have this seam too...perhaps its in the model
can you send her over for a proper inspection. You didnt blow up the model of sexycyborg did you?
Edited 2 time(s). Last edit at 03/14/2017 06:42PM by MechaBits.