cant sort the crack out
Posted by munchit1
|
cant sort the crack out March 11, 2017 11:59PM |
hi all, having a problem with these medical clitorus stl prints of the net from france.
basically, cannot sort the seem join, i've pondered it a while, then tinkered, the seem join 'plus' and 'minus' on the software both make it worse, so, i'm thinking the E0 steps per mm (theyre spot on), or secondly the prime speed and or prime amount need turning up? will that sort it? any sugestions?
Edited 1 time(s). Last edit at 03/12/2017 12:03AM by munchit1.
basically, cannot sort the seem join, i've pondered it a while, then tinkered, the seem join 'plus' and 'minus' on the software both make it worse, so, i'm thinking the E0 steps per mm (theyre spot on), or secondly the prime speed and or prime amount need turning up? will that sort it? any sugestions?
Edited 1 time(s). Last edit at 03/12/2017 12:03AM by munchit1.
|
Re: cant sort the crack out March 12, 2017 03:47AM |
hmmm sort one the other over does...ffff enough for tinight as it light now... next gues, bed leval?? any one?
|
Re: cant sort the crack out March 14, 2017 09:40PM |
Thats a mighty large clitoris you have there...you know all humans have this seam too...perhaps its in the model
can you send her over for a proper inspection. You didnt blow up the model of sexycyborg did you?
Edited 2 time(s). Last edit at 03/14/2017 09:42PM by MechaBits.
can you send her over for a proper inspection. You didnt blow up the model of sexycyborg did you?
Edited 2 time(s). Last edit at 03/14/2017 09:42PM by MechaBits.
|
Re: cant sort the crack out March 15, 2017 08:25PM |
think i've sussed the crack out...couple other bits to re adjust after a filoment change.
PLA
1mm exsrusions
0.4 layer height
2 loops
no infill
support generated (think i've sussed that setting too..ish )
45mms printing
0.8 nozzle
head temp 195
bed temp 65
wet spounged uhu on the bed.
Edited 1 time(s). Last edit at 03/15/2017 08:27PM by munchit1.
PLA
1mm exsrusions
0.4 layer height
2 loops
no infill
support generated (think i've sussed that setting too..ish )
45mms printing
0.8 nozzle
head temp 195
bed temp 65
wet spounged uhu on the bed.
Edited 1 time(s). Last edit at 03/15/2017 08:27PM by munchit1.
|
Re: cant sort the crack out March 15, 2017 09:35PM |
Freaky Gonads hope your not doing backstreet cosmetic enhancements.
hope your not doing backstreet cosmetic enhancements.
|
Re: cant sort the crack out March 16, 2017 12:52AM |
Quote
MechaBits
Freaky Gonads
ohh, i'm trying, very very trying lol
Sorry, only registered users may post in this forum.