I have a prusa i3 from folger tech with a ramps 1.4 board. I was adjusting the pots and there was a little smoke so i stopped everything and check incrementally. The arduino works fine, the RAMPS board has power and the nozzle extrudes and the z axis moves when connected and manually commanded. The X and Y axis would not move however so i figured I must have killed the stepper driver so i replaced the two off of an old board and something weird happened when i went to test it, if i move the X and Y axis nothing happens but when I home X and Y the Z axis moves. I'm ordering a new RAMPS board as i assume that must be the problem but didn't know if anyone had any insight. Any help is appreciated, thanks!